>>Application
This method applies to wastewater with total phosphorus concentrations within the range of 0-50 mg/L. Most common ions do not interfere with the determination. However, for samples containing high levels of organic matter, measurements may result in underestimated values.
>>Technical parameters
1. Measurement Method: Phosphomolybdate spectrophotometric method
2. Measurement Range: 0-50 mg/L
3. Accuracy: ≤±10%
4. Repeatability: ≤±5%
5. Measurement Cycle: Minimum cycle is 30 minutes; color development time can be adjusted flexibly between 5-30 min based on environmental conditions.
6. Sampling Cycle: Adjustable time interval (10-9999 min) or on-the-hour measurement mode.
7. Calibration Cycle: Adjustable at any interval from 1-99 days.
8. Maintenance Cycle: ≥168 hours, with each maintenance lasting ~1 hour.
9. Reagent Consumption: <0.50 CNY per sample.
10. Outputs: RS-232, 4mA-20mA, RS-485.
11. Environmental Requirements: Temperature-controlled indoor environment (recommended: 5-40°C); humidity 45%-85%.
12. Power Supply: AC 220±10% V, 50±1% Hz, 5A.
13. Dimensions: Height 1500 × Width 500 × Depth 450 mm.
14. Additional Features:
- Data retention during abnormal alarms or power outages.
- Touchscreen display and command input.
- Automatic discharge of residual reactants and resumption of operation after power restoration or system reset.
>>Feature
Unique Design: This product features a distinctive design that ensures lower failure rates, reduced maintenance requirements, minimal reagent consumption, and higher cost-effectiveness compared to similar products.
-
Selector Valve Assembly:
- Enables flexible reagent sampling timing and diverse channel configurations.
- Minimizes dead volume for easy maintenance and extended service life.
-
Micro-Dosing Unit:
- Utilizes a visual photoelectric system for precise reagent measurement, eliminating quantitative errors caused by peristaltic pump tube wear.
- Achieves accurate micro-dosing with 0.7 mL per dose, significantly reducing reagent usage.
-
Sample Introduction Unit:
- Employs a peristaltic pump with negative pressure suction, creating an air buffer zone between reagents and the pump tube to prevent corrosion.
- Simplifies and enhances flexibility in reagent mixing.
-
Sealed Digestion Unit:
- Operates under high-temperature and high-pressure conditions to accelerate reactions.
- Eliminates corrosion risks from volatile gases in open systems.
-
Reagent Tubing:
- Uses imported modified PTFE (polytetrafluoroethylene) transparent tubing with an inner diameter >1.5 mm to minimize clogging by particulate matter in water samples.
>>Analytical Principle
The mixture of the water sample, catalyst solution, and a strong oxidizing digestion solution is heated to a specified temperature. Under high-temperature and high-pressure acidic conditions, polyphosphates and other phosphorus-containing compounds in the water sample are digested and oxidized by the strong oxidizing agent to produce phosphate ions. In the presence of the catalyst, the phosphate ions react with a strongly acidic solution containing molybdate to form a colored complex. The analyzer detects this color change, converts it into a total phosphorus concentration value, and outputs the result. The amount of colored complex formed corresponds to the total phosphorus concentration.
